Search results
Results from the WOW.Com Content Network
While half-wave and full-wave rectification deliver unidirectional current, neither produces a constant voltage. There is a large AC ripple voltage component at the source frequency for a half-wave rectifier, and twice the source frequency for a full-wave rectifier. Ripple voltage is usually specified peak-to-peak.
Active full-wave rectification with two MOSFETs and a center tap transformer. Replacing a diode with an actively controlled switching element such as a MOSFET is the heart of active rectification. MOSFETs have a constant very low resistance when conducting, known as on-resistance (R DS(on)). They can be made with an on-resistance as low as 10 ...
The characteristics and components of ripple depend on its source: there is single-phase half- and full-wave rectification, and three-phase half- and full-wave rectification. Rectification can be controlled (uses Silicon Controlled Rectifiers (SCRs)) or uncontrolled (uses diodes). There is in addition, active rectification which uses transistors.
Pulsed DC is commonly produced from AC (alternating current) by a half-wave rectifier or a full-wave rectifier. Full wave rectified ac is more commonly known as Rectified AC. PDC has some characteristics of both alternating current (AC) and direct current (DC) waveforms. The voltage of a DC wave is roughly constant, whereas the voltage of an AC ...
Between the circuit's input and output is a diode that performs half-wave rectification, allowing substantial current flow only when the input voltage is around a diode drop higher than the output terminal. The output is connected to a capacitor of value and resistor of value in parallel to ground. The capacitor is charged as the input voltage ...
This is an accepted version of this page This is the latest accepted revision, reviewed on 8 October 2024. Circuit arrangement of four diodes Diode bridge Diode bridge in various packages Type Semiconductor Inventor Karol Pollak in 1895 Electronic symbol 2 alternating-current (AC) inputs converted into 2 direct-current (DC) outputs A hand-made diode bridge. The silver band on the diodes ...
UA025A – 10 kV, 250 mA Argon-filled, half-wave rectifier with an E27 Edison screw lamp base and an anode screw top cap; UA5A – 11 kV, 5 A Half-wave mercury-vapor rectifier with a 2-pin base and an anode screw top cap; ZD1000F – Radiation-cooled power triode up to 60 MHz, 1 kW; ZD1XB – Air-cooled AF power triode up to 1.2 kW
In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.