Search results
Results from the WOW.Com Content Network
Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed]
Vacuum technology is based on differential air pressure. Rotary vane vacuum pumps generate an operation pressure of -0.4 to -0.6 bar at the vacuum station, which is also the only element of the vacuum sewerage system that must be supplied with electricity. Interface valves are installed inside the children collection chambers. They work ...
Discharge Head, is the net head obtained at the outlet of a pump. For a centrifugal pump, the discharge pressure depends on the suction or inlet pressure as well, along with the fluid’s density. Thus, for the same flow rate of the fluid, we may have different values of discharge pressure depending on the inlet pressure.
Example Number 1: A tank with a liquid level 2 metres above the pump intake, plus the atmospheric pressure of 10 metres, minus a 2 metre friction loss into the pump (say for pipe & valve loss), minus the NPSH R curve (say 2.5 metres) of the pre-designed pump (see the manufacturers curve) = an NPSH A (available) of 7.5 metres. (not forgetting ...
Rotary piston and plunger pumps use a crank mechanism to create a reciprocating motion along an axis, which then builds pressure in a cylinder or working barrel to force gas or fluid through the pump. The pressure in the chamber actuates the valves at both the suction and discharge points. Plunger pumps are used in applications that could range ...
'S' trap inlet to drain [further explanation needed]. The air lock phenomenon can be used in a number of useful ways. An 'S' trap (a pipe that descends from a reservoir, then curves back up, then down again) allows liquid to flow from top to bottom unhindered, and gas cannot flow through the trap unless it has enough extra pressure to overcome the liquid head of the trap.
This can happen whether the pump is working or not. This situation can be avoided by placing a correctly rated positive pressure differential check valve downstream of the pump. Such a valve will only open if a minimum rated pressure differential across the valve is exceeded, something which most high-pressure metering pumps can easily exceed.
Suction Pipe - It is a pipe by which pump takes the water from the reservoir. Suction Valve - It is a non-return type valve installed on the suction pipe and helps to flow from reservoir to pump not the vice versa. Cylinder or liquid cylinder - The main component where pressure is increased. It is a hollow cylinder with coatings.