Search results
Results from the WOW.Com Content Network
In computer networking, the Point-to-Point Protocol over ATM (PPPoA) is a layer 2 data-link protocol typically used to connect domestic broadband modems to ISPs via phone lines. It is used mainly with DOCSIS and DSL carriers, by encapsulating PPP frames in ATM AAL5 .
kppp – A kde GUI frontend for pppd.; gnome-ppp – A (discontinued) gnome GUI frontend for WvDial, which in turns depends on pppd.; pppconfig – It uses the standard ppp configuration files and sets ppp up so that the standard pon and poff commands (to connect and disconnect) and plog (to list the log) can be used to control ppp.
PPP, PPPoE and PPPoA are widely used in WAN lines. PPP is a layered protocol that has three components: [4] An encapsulation component that is used to transmit datagrams over the specified physical layer. A Link Control Protocol (LCP) to establish, configure, and test the link as well as negotiate settings, options and the use of features.
PPPoE is used to connect a PC or a router to a modem via an Ethernet link and it can also be used in Internet access over DSL on a telephone line in the PPPoE over ATM (PPPoEoA) over ADSL protocol stack. PPPoE over ATM has the highest overhead of the popular DSL delivery methods, when compared with for example PPPoA (RFC 2364). [11] [12] [13] [14]
IBM Turboways ATM 155 PCI network interface card. Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.
PPPoX (PPP over X) designates a family of encapsulating communications protocols implementing Point-to-Point Protocol. Specific implementations: PPPoE: PPP over Ethernet – which can use 802.1q VLANs; PPPoA: PPP over ATM; PPTP: PPP encapsulated over GRE with a parallel control connection and some optional encryption
Power over Ethernet (PoE) describes any of several standards or ad hoc systems that pass electric power along with data on twisted-pair Ethernet cabling. This allows a single cable to provide both a data connection and enough electricity to power networked devices such as wireless access points (WAPs), IP cameras and VoIP phones .
Multiprotocol Encapsulation over ATM is specified in RFC 2684. It defines two mechanisms for identifying the protocol carried in ATM Adaptation Layer 5 (AAL5) frames. It replaces RFC 1483, a standard data link access protocol supported by DSL modems .