Search results
Results from the WOW.Com Content Network
Two crystalline forms are known, both being very similar to the corresponding potassium sulfate. Orthorhombic β-K 2 CrO 4 is the common form, but it converts to an α-form above 666 °C. [1] These structures are complex, although the chromate ion adopts the typical tetrahedral geometry. [2]
3 c 2 h 5 oh + 2 k 2 cr 2 o 7 + 8 h 2 so 4 → 3 ch 3 cooh + 2 cr 2 (so 4) 3 + 2 k 2 so 4 + 11 h 2 o The excess dichromate is determined by titration against sodium thiosulfate . Adding the amount of excess dichromate from the initial amount, gives the amount of ethanol present.
2 CrO 2− 4 + 2 H + ⇌ Cr 2 O 2− 7 + H 2 O The predominance diagram shows that the position of the equilibrium depends on both pH and the analytical concentration of chromium. [ notes 1 ] The chromate ion is the predominant species in alkaline solutions, but dichromate can become the predominant ion in acidic solutions.
β-Ni(NO 3) 2 (H 2 O) 4: trans-[Ni(H 2 O) 4 (κ 1-ONO 2) 2] none: octahedral configuration. [51] Pd(NO 3) 2 (H 2 O) 2: trans-[Pd(H 2 O) 2 (κ 1-ONO 2) 2] none: square planar coordination geometry [52] Cu(NO 3) 2 (H 2 O) [Cu(H 2 O)(κ 2-ONO 2) 2] none: octahedral configuration. Cu(NO 3) 2 (H 2 O) 1.5: uncertain: uncertain: uncertain [53] Cu(NO 3 ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
The following chart shows the solubility of various ionic compounds in water at 1 atm pressure and room temperature (approx. 25 °C, 298.15 K). "Soluble" means the ionic compound doesn't precipitate, while "slightly soluble" and "insoluble" mean that a solid will precipitate; "slightly soluble" compounds like calcium sulfate may require heat to precipitate.
Electron configuration is also a major factor, illustrated by the fact that the rates of water exchange for [Al(H 2 O) 6] 3+ and [Ir(H 2 O) 6] 3+ differ by a factor of 10 9 also. [4] Water exchange usually follows a dissociative substitution pathway, so the rate constants indicate first order reactions.
The specific heat of the human body calculated from the measured values of individual tissues is 2.98 kJ · kg−1 · °C−1. This is 17% lower than the earlier wider used one based on non measured values of 3.47 kJ · kg−1· °C−1.