Search results
Results from the WOW.Com Content Network
A is the cross-sectional area of the flow, P is the wetted perimeter of the cross-section. More intuitively, the hydraulic diameter can be understood as a function of the hydraulic radius R H, which is defined as the cross-sectional area of the channel divided by the wetted perimeter. Here, the wetted perimeter includes all surfaces acted upon ...
The cross-sectional area (′) of an object when viewed from a particular angle is the total area of the orthographic projection of the object from that angle. For example, a cylinder of height h and radius r has A ′ = π r 2 {\displaystyle A'=\pi r^{2}} when viewed along its central axis, and A ′ = 2 r h {\displaystyle A'=2rh} when viewed ...
The flow through the LVOT, or LV stroke volume (in cm 3), can be calculated by measuring the LVOT diameter (in cm), squaring that value, multiplying the value by 0.78540 (which is π/4) giving a cross sectional area of the LVOT (in cm 2) and multiplying that value by the LVOT VTI (in cm), measured on the spectral Doppler display using pulsed ...
When the cross-sectional area of a wire is doubled, the AWG will decrease by 3. (E.g. two 14 AWG wires have about the same cross-sectional area as a single 11 AWG wire.) This doubles the conductance. When the diameter of a solid round wire is doubled, the AWG will decrease by 6. (E.g. 1 mm diameter wire is ≈18 AWG, 2 mm diameter wire is ≈12 ...
In those cases, the characteristic length is the diameter of the pipe or, in case of non-circular tubes, its hydraulic diameter : = Where is the cross-sectional area of the pipe and is its wetted perimeter. It is defined such that it reduces to a circular diameter of D for circular pipes.
A barn (symbol: b) is a metric unit of area equal to 10 −28 m 2 (100 fm 2).This is equivalent to a square that is 10 −14 m (10 fm) each side, or a circle of diameter approximately 1.128 × 10 −14 m (11.28 fm).
Diagram showing definitions and directions for Darcy's law. A is the cross sectional area (m 2) of the cylinder. Q is the flow rate (m 3 /s) of the fluid flowing through the area A. The flux of fluid through A is q = Q/A. L is the length of the cylinder. Δp = p outlet - p inlet = p b - p a.
In a general physics context, sectional density is defined as: = [2] SD is the sectional density; M is the mass of the projectile; A is the cross-sectional area; The SI derived unit for sectional density is kilograms per square meter (kg/m 2). The general formula with units then becomes: