Search results
Results from the WOW.Com Content Network
Bearing pressure is a particular case of contact mechanics often occurring in cases where a convex surface (male cylinder or sphere) contacts a concave surface (female cylinder or sphere: bore or hemispherical cup). Excessive contact pressure can lead to a typical bearing failure such as a plastic deformation similar to peening.
The standard rail weight for British railways is now 113 lb/yd (56.1 kg/m). Before the 1990s, most diesel locomotives were built to a maximum axle load of 19 long tons (19.3 tonnes; 21.3 short tons) so the maximum locomotive weight was 76 long tons (77.2 tonnes; 85.1 short tons) for a four-axle locomotive and 114 long tons (115.8 tonnes; 127.7 short tons) for a six-axle one.
The two halves of the bearing are then split at the shim, the shim removed, the oil holes cleared of metal and oil ways are cut into the surface of the new bearing. The shaft is smeared with engineer's blue and rotated in the bearing. When the bearing is disassembled the blue fills the hollows and is rubbed off the high spots, making them visible.
p = bearing pressure(N/MM2) For any given bearing, there is a value for indicated by C, for which the coefficient of friction is at a minimum. The bearing should not be operated at this value of bearing modulus, since a slight decrease in speed or a slight increase in pressure will make the part of a shaft or axle that rests on bearings operate ...
In many applications tapered roller bearings are used in back-to-back pairs so that axial forces can be supported equally in either direction. Pairs of tapered roller bearings are used in car and vehicle wheel bearings where they must cope simultaneously with large vertical (radial) and horizontal (axial) forces.
The contact area is flooded with the lubricant or grease being tested. The Timken OK Load is the highest standard load at which the spinning bearing race produces no scouring mark on the test block, but only a uniform wear scar. [1] Timken OK Loads are listed on grease and oil property charts and are part of many specifications.
A sealed deep groove ball bearing. In mechanical engineering, a rolling-element bearing, also known as a rolling bearing, [1] is a bearing which carries a load by placing rolling elements (such as balls, cylinders, or cones) between two concentric, grooved rings called races.
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.