enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. High-density polyethylene - Wikipedia

    en.wikipedia.org/wiki/High-density_polyethylene

    HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]

  3. HDPE pipe - Wikipedia

    en.wikipedia.org/wiki/HDPE_pipe

    HDPE pipe is a type of flexible plastic pipe used to transfer fluids and gases. It is often employed for replacing aging concrete or steel main pipelines . Constructed from the thermoplastic HDPE (high-density polyethylene ), it has low permeability and robust molecular bonding, making it suitable for high-pressure pipelines .

  4. Polyethylene - Wikipedia

    en.wikipedia.org/wiki/Polyethylene

    HDPE pipe on site during installation in outback Western Australia. The white outer layer, Acu-Therm, is co-extruded to provide a reduction of thermal heating. HDPE is defined by a density of greater or equal to 0.941 g/cm 3. HDPE has a low degree of branching.

  5. Low-density polyethylene - Wikipedia

    en.wikipedia.org/wiki/Low-density_polyethylene

    Low-density polyethylene (LDPE) is a thermoplastic made from the monomer ethylene. It was the first grade of polyethylene, produced in 1933 by John C. Swallow and M.W Perrin who were working for Imperial Chemical Industries (ICI) using a high pressure process via free radical polymerization. [1] Its manufacture employs the same method today.

  6. Expanded polyethylene - Wikipedia

    en.wikipedia.org/wiki/Expanded_polyethylene

    EPE foams are low density, semi-rigid, closed cell foam that are generally somewhere in stiffness/compliance between Expanded polystyrene and Polyurethane. Production of EPE foams is similar to that of expanded polystyrene, but starting with PE beads. [1] Typical densities are 29 to 120 kg/m 3 (49 to 202 lb/cu yd) with the lower figure being ...

  7. Plastic pipework - Wikipedia

    en.wikipedia.org/wiki/Plastic_pipework

    Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.

  8. Cross-linked polyethylene - Wikipedia

    en.wikipedia.org/wiki/Cross-linked_polyethylene

    A cross-linked polyethylene (PEX) pipe. Cross-linked polyethylene, commonly abbreviated PEX, XPE or XLPE, is a form of polyethylene with cross-links.It is used predominantly in building services pipework systems, hydronic radiant heating and cooling systems, domestic water piping, insulation for high tension (high voltage) electrical cables, and baby play mats.

  9. Use of HDPE in nuclear power plant piping systems - Wikipedia

    en.wikipedia.org/wiki/Use_of_HDPE_in_Nuclear...

    Pipe Surface Alignment: A change in the pipe outside diameter (O.D.) surface misalignment of more than 10 percent of the wall thickness of the thinner member to be fused. (3) PE Material: Each lot of polyethylene source material to be used in production (XXVI–2310(c)). (4) Wall Thickness: Each thickness to be fused in production (XXVI–2310(c)).