Search results
Results from the WOW.Com Content Network
When the brake pipe and car components are charged with air, the brakes release. When the engineer needs to make a brake application, control valves in the locomotive reduce the brake pipe pressure. As the brake pipe pressure is reduced, the service portions on each car divert air from their reservoirs to their brake cylinders.
The presence of the voltage holds the brakes off, providing a fail safe system. The 3 step "Westcode" brake uses three wires and these operate in a binary sequence to control the brake step. 10 & 11 are the brake coding to provide the 3 steps, 12 wire is emergency brake, 15 wire is EP brake negative. Positions on the brake handle are:
European brake systems vary between countries, but the working principle is the same as for the Westinghouse air brake. European passenger cars used on national railway networks must comply with TSI LOC&PAS regulation, [12] which specifies in section 4.2.4.3 that all brake systems must adhere to the EN 14198:2004 standard.
Electric park brake in the center console in a Volkswagen Golf Variant. An electronic parking brake (EPB), also known as an electric parking brake or electric park brake, is an electronically controlled parking brake, whereby the driver activates the holding mechanism with a button and the brake pads are electrically applied to the rear wheels. [1]
Sensotronic Brake Control (SBC) is an electro-hydraulic brake system developed by Daimler and Bosch. In this system, the wheel brake cylinders of a vehicle are operated through a servomechanism, offering precise and responsive braking. The SBC system was first introduced on the R230 SL-class, which was released in Europe in October 2001. [1]
Electronic brakeforce distribution (EBD or EBFD) or electronic brakeforce limitation (EBL) is an automobile brake technology that automatically varies the amount of force applied to each of a vehicle's wheels, based on road conditions, speed, loading, etc, thus providing intelligent control of both brake balance and overall brake force.
SpeedE, an academic concept car developed for studying drive-by-wire technologies such as brake-by-wire. Brake-by-wire technology in the automotive industry is the ability to control brakes through electronic means, without a mechanical connection that transfers force to the physical braking system from a driver input apparatus such as a pedal or lever.
Modern WSP systems are microprocessor controlled and employ two stage valves that permit fine control over the air pressure in the brake cylinders. This is essential to be able to capture and control a sliding wheel and to minimise the amount of air resource used by the WSP. When the brake is applied, the WSP first applies the dynamic brake.