enow.com Web Search

  1. Ads

    related to: antenna and cable input splitter combo for sale by owner near me zillow 16510

Search results

  1. Results from the WOW.Com Content Network
  2. SMATV - Wikipedia

    en.wikipedia.org/wiki/SMATV

    The system consists of a master antenna and a matching transformer to match the balanced antenna with unbalanced cable and amplifiers. [5] Most antennas have an impedance of around 300 Ω. To convert it to 75 Ω, a matching transformer (or balun) is used. For trunk line isolation, a resistive inductive device known as a splitter is used. The ...

  3. Power dividers and directional couplers - Wikipedia

    en.wikipedia.org/wiki/Power_dividers_and...

    From left to right: input, coupled, isolated (terminated with a load), and transmitted port. A 3 dB 2.0–4.2 GHz power divider/combiner. Power dividers (also power splitters and, when used in reverse, power combiners) and directional couplers are passive devices used mostly in the field of radio technology.

  4. Antenna amplifier - Wikipedia

    en.wikipedia.org/wiki/Antenna_amplifier

    In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

  5. SMA connector - Wikipedia

    en.wikipedia.org/wiki/SMA_connector

    The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.

  6. Wilkinson power divider - Wikipedia

    en.wikipedia.org/wiki/Wilkinson_power_divider

    The , are almost -3 dB, and the is low near the design frequency. Picture demonstrates a very high isolation between output ports (port 2 & 3) of a Wilkinson power divider The scattering parameters for the common case of a 2-way equal-split Wilkinson power divider at the design frequency is given by [ 3 ]

  7. Diplexer - Wikipedia

    en.wikipedia.org/wiki/Diplexer

    That cable would then run from the roof into the house. At a convenient point, a second diplexer would split the two signals apart; one signal would go to the TV set and the other to the IRD of the DBS set-top box. These usually have an antenna input and a diplexer, so that the antenna signal is also distributed along with the satellite.

  1. Ads

    related to: antenna and cable input splitter combo for sale by owner near me zillow 16510