Search results
Results from the WOW.Com Content Network
The Chevrolet Inline-4 engine was one of Chevrolet's first automobile engines, designed by Arthur Mason and introduced in 1913. Chevrolet founder Billy Durant, who previously had owned Buick which had pioneered the overhead valve engine, used the same basic engine design for Chevrolet: exposed pushrods and rocker arms which actuated valves in the detachable crossflow cylinder head.
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
High energy ignition, also known as H.E.I., is an electronic ignition system designed by the Delco-Remy Division of General Motors.It was used on all GM vehicles, at least in the North American market, from 1975 through the mid-1980s.
Some engines, such as GM's Premium V family, use crank position sensors which read a reluctor ring integral to the harmonic balancer. This is a much more accurate method of determining the position of the crankshaft and allows the computer to determine, within a few degrees, the exact position of the crankshaft (and thereby all connected ...
GM continued to develop and refine the 231 cu in (3.8 L) V6, eventually and commonly referred to simply as the 3800, through numerous iterations. The 3800 made the Ward's 10 Best Engines of the 20th Century list and made Ward's yearly 10 Best list numerous times. It is one of the most-manufactured engines in automotive history, with over 25 ...
The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.
The first mass-produced electric ignition was the Delco ignition system, which was introduced in the 1910 Cadillac Model 30. In 1921, Arthur Atwater Kent Sr invented the competing Unisparker ignition system. [2] By the 1980s and 1990s, distributors had been largely replaced by electronic ignition systems.
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942. The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting ...