enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. RF switch matrix - Wikipedia

   en.wikipedia.org/wiki/RF_Switch_Matrix

   There are six main challenges when designing a custom RF/Microwave Switch Matrix from beginning to end: Mechanical Design: design of an electrically shielded enclosure or box, internal component mounting brackets, with a component and cabling layout. RF/Microwave Design: a signal routing and signal conditioning design and testing plan. A ...

3. RF switch - Wikipedia

   en.wikipedia.org/wiki/RF_switch

   An RF switch or microwave switch is a device to route high frequency signals through transmission paths. RF (radio frequency) and microwave switches are used extensively in microwave test systems for signal routing between instruments and devices under test (DUT). Incorporating a switch into a switch matrix system enables you to route signals ...

4. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   "Switched socket-outlets and connectors with or without interlock" applies to self-contained products that combine within a single enclosure, a socket-outlet or connector according to IEC 60309-1 or IEC 60309-2 and a switching device, with a rated operating voltage not exceeding 1000 VDC or VAC and 500 Hz, and a rated current not exceeding 800 A.

5. Electrical outlet tester - Wikipedia

   en.wikipedia.org/wiki/Electrical_outlet_tester

   A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...

6. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:

7. In-circuit testing - Wikipedia

   en.wikipedia.org/wiki/In-circuit_testing

   A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.