Search results
Results from the WOW.Com Content Network
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
Unlike generic on-board diagnostics (OBD-II or EOBD), VCDS uses the more in-depth Volkswagen Group-specific manufacturer protocol commands, [4] which allows the user to access all diagnostic capable vehicle systems — even in vehicles which are not covered by generic OBD-II/EOBD (e.g. pre-1996).
The OBD-II DLC (post-1996 vehicles) is usually located under the instrument panel on the driver side, though there are several exceptions. The SAE J1962 specification provides for two standardized hardware interfaces, called type A and type B. Both are female, 16-pin (2x8), D-shaped connectors, and both have a groove between the two rows of pins.
The OBD-II specification provides for a standardized hardware interface — the female 16-pin (2x8) J1962 connector, where type A is used for 12-volt vehicles and type B for 24-volt vehicles. Unlike the OBD-I connector, which was sometimes found under the bonnet of the vehicle, the OBD-II connector is required to be within 2 feet (0.61 m) of ...
The Windows XP and Windows Vista/Windows 7 Bluetooth stacks support the following Bluetooth profiles natively: PAN, SPP, DUN, HID, HCRP. The Windows XP stack can be replaced by a third party stack that supports more profiles or newer Bluetooth versions. The Windows Vista/Windows 7 Bluetooth stack supports vendor-supplied additional profiles ...
Standard OBD requests and responses use functional addresses. The diagnostic reader initiates a query using CAN ID 7DFh, which acts as a broadcast address, and accepts responses from any ID in the range 7E8h to 7EFh. ECUs that can respond to OBD queries listen both to the functional broadcast ID of 7DFh and one assigned ID in the range 7E0h to ...
Request Download Downloading new software or other data into the control unit is introduced using the "Request Download". Here, the location and size of the data is specified. In turn, the tester specifies how large the data packets can be. 0x35 0x75 Request Upload The service "request upload" is almost identical to the service "Request Download".
1.6 — all of 1.5 plus browsing data and track information [10] Number of items that are in a folder without downloading the list; Support for transmitting cover arts through the BIP over OBEX protocol. 1.6.1 [11] and 1.6.2 [12] correct minor errors in tables. [13] [14]