Search results
Results from the WOW.Com Content Network
Milli (symbol m) is a unit prefix in the metric system denoting a factor of one thousandth (10 −3). [1] Proposed in 1793, [2] and adopted in 1795, the prefix comes from the Latin mille, meaning one thousand (the Latin plural is milia).
1 km 2 means one square kilometre, or the area of a square of 1000 m by 1000 m. In other words, an area of 1 000 000 square metres and not 1000 square metres. 2 Mm 3 means two cubic megametres, or the volume of two cubes of 1 000 000 m by 1 000 000 m by 1 000 000 m, i.e. 2 × 10 18 m 3, and not 2 000 000 cubic metres (2 × 10 6 m 3).
4–8 ms: The typical seek time for a computer hard disk: 10 −2: centisecond cs One hundredth of one second 1.6667 cs: The period of a frame at a frame rate of 60 Hz. 2 cs: The cycle time for European 50 Hz AC electricity 10–20 cs (=0.1–0.2 s): The human reflex response to visual stimuli 10 −1: decisecond ds One tenth of a second
2.100 Mm – length of proposed Iran-Pakistan-India gas pipe; 2.100 Mm – distance from Casablanca to Rome; 2.288 Mm – length of the official Alaska Highway when it was built in the 1940s [161] 3.069 Mm – length of Interstate 95 (from Houlton, Maine, to Miami, Florida) 3.846 Mm – length of U.S. Route 1 (from Fort Kent, Maine, to Key West ...
~ 10 −3 s: Used to measure the time between alternating power cycles. Also a casual term for a short period of time. centisecond: 10 −2 s: One hundredth of a second. decisecond: 10 −1 s: One tenth of a second. second: 1 s: SI base unit for time. decasecond: 10 s: Ten seconds (one sixth of a minute) minute: 60 s: hectosecond: 100 s ...
The prefixes myria-, [2] [3] [4] (from the Greek μύριοι, mýrioi), double-and demi-, denoting factors of 10 000, 2 and 1 ⁄ 2 respectively, [5] were parts of the original metric system adopted in France in 1795, but they were not retained when the SI prefixes were agreed internationally by the 11th CGPM conference in 1960.
In the SI system and generally in older metric systems, multiples and fractions of a unit can be described via a prefix on a unit name that implies a decimal (base-10), multiplicative factor. The only exceptions are for the SI-accepted units of time (minute and hour) and angle (degree, arcminute, arcsecond) which, based on ancient convention ...
Until then, workers such as millwrights, boilermakers, and machinists in the Anglosphere measured only in traditional fractions of an inch, divided via successive halving, usually only as far as 64ths (1, 1 ⁄ 2, 1 ⁄ 4, 1 ⁄ 8, 1 ⁄ 16, 1 ⁄ 32, 1 ⁄ 64). Each 64th is about 16 thou.