Search results
Results from the WOW.Com Content Network
RIPng (RIP next generation) is an extension of RIPv2 for support of IPv6, the next generation Internet Protocol. [12] The main differences between RIPv2 and RIPng are: Support of IPv6 networking. While RIPv2 supports RIPv1 updates authentication, RIPng does not. IPv6 routers were, at the time, supposed to use IPsec for authentication. [citation ...
An interior gateway protocol (IGP) or interior routing protocol is a type of routing protocol used for exchanging routing table information between gateways (commonly routers) within an autonomous system (for example, a system of corporate local area networks). [1] This routing information can then be used to route network-layer protocols like IP.
Routing protocols, according to the OSI routing framework, are layer management protocols for the network layer, regardless of their transport mechanism: IS-IS runs on the data link layer (Layer 2) Open Shortest Path First (OSPF) is encapsulated in IP, but runs only on the IPv4 subnet, while the IPv6 version runs on the link using only link ...
In order to address the issues of address space and other factors, Cisco created EIGRP (Enhanced Interior Gateway Routing Protocol). EIGRP adds support for VLSM (variable length subnet mask) and adds the Diffusing Update Algorithm (DUAL) in order to improve routing and provide a loopless environment.
Examples of address families include 32-bit IPv4 addresses, 128-bit IPv6 addresses, X.121 addresses used by the X.25 protocol suite, E.164 telephone numbers, and F.69 Telex addresses. [1] Address family identifiers are used in communications protocols and APIs that support multiple network address schemes, including routing protocols such as ...
The term distance vector refers to the fact that the protocol manipulates vectors of distances to other nodes in the network. The distance vector algorithm was the original ARPANET routing algorithm and was implemented more widely in local area networks with the Routing Information Protocol (RIP).
The link-state protocol is performed by every switching node in the network (i.e., nodes which are prepared to forward packets; in the Internet, these are called routers). [3] The basic concept of link-state routing is that every node constructs a map of the connectivity to the network in the form of a graph , showing which nodes are connected ...
The example below shows how to configure the administrative distance to 254 to specify that it should only be used as a last resort. R1(config)# ip route 10.0.0.0 255.0.0.0 backupLink 1 254 In the event that two routing protocols are configured with the same administrative distance, the Cisco router will ignore the configured values and instead ...