Search results
Results from the WOW.Com Content Network
Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.
A single or a few LED junctions may be packed in one miniature device for use as an indicator or pilot lamp. An LED array may include controlling circuits within the same package, which may range from a simple resistor, blinking or color changing control, or an addressable controller for RGB devices. Higher-powered white-emitting devices will ...
The inner workings of an LED, showing circuit (top) and band diagram (bottom) The p–n junction in any direct band gap material emits light when electric current flows through it. This is electroluminescence. Electrons cross from the n-region and recombine with the holes existing in the p-region.
A symmetric layout of Charlieplexed LEDs. On left, 3 pins drive 6 LEDs arranged in a triangle. On right, 4 pins drive 12 LEDs arranged in a tetrahedron.. The Charlieplexing configuration may be viewed as a directed graph, where the drive pins are vertices and the LEDs are directed edges; there is an outward-pointing edge connected from each vertex to each other vertex, hence with n drive pins ...
Reverse bias: Although the LED is based on a diode junction and is nominally a rectifier, the reverse-breakdown mode for some types can occur at very low voltages and essentially any excess reverse bias can cause immediate degradation, and may lead to vastly accelerated failure. 5 V is a typical maximum reverse bias voltage specification for ...
A twinkle bulb is a special type of light bulb which blinks on and off for decorative effect. They are most commonly used on Christmas lights and other string lights, but can also be used for other ornamental purposes like electric jack-o-lanterns for Halloween and replica traffic lights.
The International Blinking Pattern Interpretation (IBPI) is an internal computer hardware standard. It defines two items: It defines two items: How SGPIO is interpreted into states for drives or slots on a backplane.
In the electrical schematic shown, a typical light dimmer based on a silicon-controlled rectifier (SCR) dims the light through phase-angle control. This unit is wired in series with the load. Diodes (D2, D3, D4 and D5) form a bridge, which generates pulsed DC. R1 and C1 form a circuit with a time constant.