Search results
Results from the WOW.Com Content Network
At the destination, a second UART re-assembles the bits into complete bytes. Each UART contains a shift register, which is the fundamental method of conversion between serial and parallel forms. Serial transmission of digital information (bits) through a single wire or other medium is less costly than parallel transmission through multiple wires.
It is sometimes called a four-wire serial bus to contrast with three-wire variants which are half duplex, and with the two-wire I²C and 1-Wire serial buses. Typical applications include interfacing microcontrollers with peripheral chips for Secure Digital cards, liquid crystal displays , analog-to-digital and digital-to-analog converters ...
Synchronous Serial Interface (SSI) is a widely used serial interface standard for industrial applications between a master (e.g. controller) and a slave (e.g. sensor). SSI is based on RS-422 [1] standards and has a high protocol efficiency in addition to its implementation over various hardware platforms, making it very popular among sensor manufacturers.
So, an analog-to-digital converter (ADC) is used to convert the incoming data into a form that the processor can recognize. A less common feature on some microcontrollers is a digital-to-analog converter (DAC) that allows the processor to output analog signals or voltage levels.
This uses the same ATmega328 as late-model Duemilanove, but whereas the Duemilanove used an FTDI chip for USB, the Uno uses an ATmega16U2 (ATmega8U2 before rev3) programmed as a serial converter. Arduino Mega2560 [24] Arduino Yes ATmega2560 [25] 16 MHz Mega 4 in × 2.1 in [ 101.6 mm × 53.3 mm ] USB 8U2 [22] (Rev1&2)/ 16U2 [11] (Rev3) 5 V 256 4 8
Input and output voltages are usually, but not always, limited to the supply voltage of the device with the GPIOs, and may be damaged by greater voltages. A GPIO pin's state may be exposed to the software developer through one of a number of different interfaces, such as a memory-mapped I/O peripheral, or through dedicated IO port instructions.
SIOX is an asynchronous serial communication bus that uses 300 – 19 200 bit/s (default 4800) datarates. Specified by Telefrang AB in Sweden, it is widely used in factories, plants, ships and district heating systems.
English: Contents of Serial Programming that has been turned into a PDF file as a "published" book. Version as of date of PDF file. Version as of date of PDF file. This file was created with MediaWiki to LaTeX .