Ad
related to: thread depth for 14mm x2 converter kit- Crazy, So Cheap？
Limited time offer
Hot selling items
- Top Sale Items
Daily must-haves
Special for you
- Men's Clothing
Limited time offer
Hot selling items
- Our Picks
Highly rated, low price
Team up, price down
- Crazy, So Cheap？
Search results
Results from the WOW.Com Content Network
The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.
A perfectly sharp 60° V-thread will have a depth of thread ("height" from root to crest) equal to 0.866 of the pitch. This fact is intrinsic to the geometry of an equilateral triangle — a direct result of the basic trigonometric functions. It is independent of measurement units (inch vs mm). However, UTS and ISO threads are not sharp threads.
Whitworth's new standard specified a 55° thread angle and a thread depth of 0.640327p and a radius of 0.137329p, where p is the pitch. The thread pitch increases with diameter in steps specified on a chart. The Whitworth thread system was later to be adopted as a British Standard to become British Standard Whitworth (BSW).
The thread depth is 0.54125 × pitch. The outermost 1 ⁄ 8 and the innermost 1 ⁄ 4 of the height H of the V-shape are cut off from the profile. The relationship between the height H and the pitch P is found using the following equation where θ is half the included angle of the thread, in this case 30°: [ 3 ]
The design was first proposed by the British Association in 1884 [1] [2] with a thread angle and depth based on the Swiss Thury thread, [3] it was adopted by the Association in 1903. The Thury thread was different in that it went both positive and negative all the way up to a size of −20 which was 75.2 mm diameter by 8.23 mm pitch ( p ).
The sealants, where used, are typically thread seal tape thread sealant or a thread seal paste pipe dope (sometimes similar in composition to plumber's putty). Because the thread body is tapered (0.75 in/ft or 62.5 mm/m), a larger diameter keeps compressing into a smaller diameter and finally forms a seal (no clearance remains between the ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
United States Standard thread (USS thread), also known as Sellers Standard thread, [1] Franklin Institute thread [1] and American Standard thread, [2] is a standard for inch based threaded fasteners and washers. [3] The USS standard is no longer supported. It, together with the SAE fastener standard, was incorporated into the Unified Thread ...
Ad
related to: thread depth for 14mm x2 converter kit