enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.

3. Collet - Wikipedia

   en.wikipedia.org/wiki/Collet

   Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.

4. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   Collets can also be obtained to fit Morse or Brown and Sharpe taper sockets. Typically collets offer higher levels of precision and accuracy than self-centering chucks, and have a shorter setting up time than independent-jaw chucks. The penalty is that most collets can only accommodate a single size of workpiece.

5. Milling (machining) - Wikipedia

   en.wikipedia.org/wiki/Milling_(machining)

   Milling centers are generally classified as vertical machining centers (VMCs) or horizontal machining centers (HMCs). The integration of milling into turning environments, and vice versa, began with live tooling for lathes and the occasional use of mills for turning operations. This led to a new class of machine tools, multitasking machines ...

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   Twist drill bit with Morse taper shank. 11 ... (live, dead, or driven) center to locate the part about an axis. ... typically mount in a collet rather than a chuck, ...

7. Lathe center - Wikipedia

   en.wikipedia.org/wiki/Lathe_center

   There are two types of cup centers. The woodworking variety is a variation of the traditional live center. This type of cup center has a central point like a normal live center and also has a ring surrounding it. The ring supports the softer material around the center point and prevents the wood from splitting under pressure from the central point.

8. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   The smaller top item is an insert, the middle shows another three-fluted counterbore insert, assembled in the holder. The shank of this holder is a Morse taper, although there are other machine tapers that are used in the industry. The lower counterbore is designed to fit into a drill chuck, and being smaller, is economical to make as one piece.

9. Talk:Machine taper - Wikipedia

   en.wikipedia.org/wiki/Talk:Machine_taper

   Morse taper is inch-based and should be defined as such. 216.152.18.131 17:17, 3 September 2020 (UTC) I was puzzled by this, too. It appears to date nearly the creation of this article. In May 2005 DerrickOswald added the Morse taper dimensions to this article, and they were the only actual dimensions in it (the article was stubbed in March of ...