Search results
Results from the WOW.Com Content Network
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Pebbledash Pebbledashing Rock dash stucco. Roughcast or pebbledash is a coarse plaster surface used on outside walls that consists of lime and sometimes cement mixed with sand, small gravel and often pebbles or shells. [1] The materials are mixed into a slurry and are then thrown at the working surface with a trowel or scoop.
Common stucco for external work is usually composed of one part hydraulic lime and three parts sand. The wall should be sufficiently rough to form a key and well wetted to prevent the moisture being absorbed from the plaster. Rough stucco is used to imitate stonework. It is worked with a hand float covered with rough felt (a stiff bristled ...
Stucco or render is a construction material made of aggregates, a binder, and water. Stucco is applied wet and hardens to a very dense solid. It is used as a decorative coating for walls and ceilings, exterior walls, and as a sculptural and artistic material in architecture.
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
The detachment of wall paintings involves the removal of a wall painting from the structure of which it formed part. While detachment was once a common practice, the preservation of art in situ is now preferred, and detachment is now largely restricted to cases where the only alternative is total loss. [ 1 ]
Caulk (also known as caulking and calking) [1] is a material used to seal joints or seams against leakage in various structures and piping. The oldest form of caulk consisted of fibrous materials driven into the wedge-shaped seams between boards on wooden boats or ships. Cast iron sewerage pipes were formerly caulked in a similar way.
Sometimes, stucco would be used in molds to create more intricate designs. The architects would apply multiple layers of stucco to the walls and then afterwards press the carved molds, which were typically made out of hardwood, onto the stucco to cast the design on the wall. This also allowed for a more rapid recreation of complex designs. [30]