Ad
related to: marine waterline tape measure for aluminum boats reviews problemszoro.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
In sailing and boating, a vessel's freeboard is the distance from the waterline to the upper deck level, measured at the lowest point of sheer where water can enter the boat or ship. [1] In commercial vessels, the latter criterion measured relative to the ship's load line, regardless of deck arrangements, is the mandated and regulated meaning. [2]
A vessel's length at the waterline (abbreviated to L.W.L) [1] is the length of a ship or boat at the level where it sits in the water (the waterline). The LWL will be shorter than the length of the boat overall (length overall or LOA) as most boats have bows and stern protrusions that make the LOA greater than the LWL. As a ship becomes more ...
A hull is the watertight body of a ship, boat, submarine, or flying boat. The hull may open at the top (such as a dinghy), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures, such as a funnel, derrick, or mast. The line where the hull meets the water surface is called the waterline.
Deadweight tonnage (DWT) is a measure of how much weight a ship can carry. [1] [2] [3] It is the sum of the weights of cargo, fuel, fresh water, ballast water, provisions, passengers, and crew. [1] Draft or draught (d) or (T) – The vertical distance from the bottom of the keel to the waterline. Used mainly to determine the minimum water depth ...
This is how some racing boats and tall ships use the term LOA. [3] However, other sources may include bowsprits in LOA. [4] Confusingly, LOA has different meanings. [5] [6] "Sparred length", "Total length including bowsprit", "Mooring length" and "LOA including bowsprit" are other expressions that might indicate the full length of a sailing ship.
A ship's draft/draught is the "depth of the vessel below the waterline measured vertically to the lowest part of the hull, propellers, or other reference point". [1] That is, the draft or draught is the maximum depth of any part of the vessel, including appendages such as rudders, propellers and drop keels if deployed.
For common tape measurements, the tape used is a steel tape with coefficient of thermal expansion C equal to 0.000,011,6 units per unit length per degree Celsius change. This means that the tape changes length by 1.16 mm per 10 m tape per 10 °C change from the standard temperature of the tape.
For the International rule, the rating number is approximately equal to the sailing length of the hull. These boats have long overhangs which allow the waterline length to increase as the boat heels over. A displacement hull's maximum speed (the hull speed) is directly proportional to the square root of its waterline length. [2]
Ad
related to: marine waterline tape measure for aluminum boats reviews problemszoro.com has been visited by 1M+ users in the past month