Search results
Results from the WOW.Com Content Network
These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...
The oil is contained in a reservoir that connects to a small oil pump in the engine, which needs to be periodically refilled. Oil injection pump on a Yamaha DX100 - just behind the carburettor (visible on the left) It is the primary component of two-stroke automatic lubrication system.
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered ...
About 100 units were built, [2] of which some 3- and 4-rotor units were installed in the Mercedes-Benz C 111 experimental sports car, from 1969 until 1970, as a mid-engine. [3] Although scheduled for commercial introduction in 1970 as a 2-rotor engine, the M 950 had not reached the series production stage by 1972.
Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a valve shuts the oil inlet.
A jacking gear (also known as a turning gear) is a device placed on the main shaft of an engine or the rotor of a turbine. The jacking gear rotates the shaft or rotor and associated machinery (such as reduction gears and main steam or gas turbines), to ensure uniform cool-down. Without turning, hogging or sagging can occur.
The M4+2 engine, also known as the double-piston internal combustion engine, is a type of internal combustion engine invented by Polish patent holder Piotr Mężyk. [1] The M4+2 engine took its name from a combination of two-stroke engines and four-stroke engines. The two-stroke combustion engine is characterized by a simple construction and ...
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...