Search results
Results from the WOW.Com Content Network
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered engines.
The oil is contained in a reservoir that connects to a small oil pump in the engine, which needs to be periodically refilled. Oil injection pump on a Yamaha DX100 - just behind the carburettor (visible on the left) It is the primary component of two-stroke automatic lubrication system.
These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...
Animation of a two-stroke engine. A two-stroke (or two-stroke cycle) engine is a type of internal combustion engine that completes a power cycle with two strokes of the piston (one up and one down movement) in one revolution of the crankshaft in contrast to a four-stroke engine which requires four strokes of the piston in two crankshaft revolutions to complete a power cycle.
The tendency of the variable force on the upper slide is to lift the machine off its lead springs at half-stroke, and ease it down at the ends of stroke. This causes a pitching, and because the maximum up force is not simultaneous for the two cylinders, it will also tend to roll on the springs. [32]
A rotary valve in the form of a flat disc, also known as a disc valve, is used in two-stroke motorcycle engines, where the arrangement helps to prevent reverse flow back into the intake port during the compression stroke. Austrian engine manufacturer Rotax used rotary intake valves in their now out-of-production 64 hp (48 kW) Rotax 532 two ...
Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a check valve shuts the oil inlet ...
About 100 units were built, [2] of which some 3- and 4-rotor units were installed in the Mercedes-Benz C 111 experimental sports car, from 1969 until 1970, as a mid-engine. [3] Although scheduled for commercial introduction in 1970 as a 2-rotor engine, the M 950 had not reached the series production stage by 1972.