Search results
Results from the WOW.Com Content Network
These engines were designed to have a total-loss lubrication system, with the motor oil held in a separate tank from the fuel in the vehicle, and not pre-mixed with it as with two-cycle engines, but mixed within the engine instead while running. Castor oil was often used because it lubricates well at the high temperatures found in air-cooled ...
The oil is contained in a reservoir that connects to a small oil pump in the engine, which needs to be periodically refilled. Oil injection pump on a Yamaha DX100 - just behind the carburettor (visible on the left) It is the primary component of two-stroke automatic lubrication system.
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered ...
Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a valve shuts the oil inlet.
The M4+2 engine, also known as the double-piston internal combustion engine, is a type of internal combustion engine invented by Polish patent holder Piotr Mężyk. [1] The M4+2 engine took its name from a combination of two-stroke engines and four-stroke engines. The two-stroke combustion engine is characterized by a simple construction and ...
Another motorcycle with a rotary engine was Charles Redrup's 1912 Redrup Radial, which was a three-cylinder 303 cc rotary engine fitted to a number of motorcycles by Redrup. In 1904 the Barry engine , also designed by Redrup, was built in Wales: a rotating 2-cylinder boxer engine weighing 6.5 kg [ 3 ] was mounted inside a motorcycle frame.
A jacking gear (also known as a turning gear) is a device placed on the main shaft of an engine or the rotor of a turbine. The jacking gear rotates the shaft or rotor and associated machinery (such as reduction gears and main steam or gas turbines), to ensure uniform cool-down. Without turning, hogging or sagging can occur.
About 100 units were built, [2] of which some 3- and 4-rotor units were installed in the Mercedes-Benz C 111 experimental sports car, from 1969 until 1970, as a mid-engine. [3] Although scheduled for commercial introduction in 1970 as a 2-rotor engine, the M 950 had not reached the series production stage by 1972.