enow.com Web Search

  1. Ad

    related to: material thickness gauge chart for steel pipe specifications pdf full screen

Search results

  1. Results from the WOW.Com Content Network
  2. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  3. Sheet metal - Wikipedia

    en.wikipedia.org/wiki/Sheet_metal

    In most of the world, sheet metal thickness is consistently specified in millimeters. In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its gauge. The larger the gauge number, the thinner the metal. Commonly used steel sheet metal ranges from 30 gauge to about 7 gauge.

  4. Steel grades - Wikipedia

    en.wikipedia.org/wiki/Steel_grades

    Where x is the material type (only 1 is specified so far), yy is the steel group number (specified in EN10027-2) and zz(zz) is a sequential number designated by the certifying body, the number in brackets being unused but reserved for later use. The steel groups are indicated below:

  5. Specified minimum yield strength - Wikipedia

    en.wikipedia.org/wiki/Specified_Minimum_Yield...

    Specified Minimum Yield Strength (SMYS) means the specified minimum yield strength for steel pipe manufactured in accordance with a listed specification 1.This is a common term used in the oil and gas industry for steel pipe used under the jurisdiction of the United States Department of Transportation.

  6. ASTM A53 steel - Wikipedia

    en.wikipedia.org/wiki/ASTM_A53_steel

    Scope of ASTM A53 Standard ASTM A53 is standard specification for pipe, steel, black and hot dipped, zinc-coated, welded and seamless. This specification covers seamless and welded black and hot-dipped galvanized steel pipe in NPS 1⁄8 to NPS 26 [DN 6 to DN 650] (Note 1), inclusive, with nominal wall thickness (Note 2) as given in Table X2.2 ...

  7. List of DIN standards - Wikipedia

    en.wikipedia.org/wiki/List_of_DIN_standards

    Seamless Steel Pipes and Tubes – Dimensions, Conventional Masses per Unit Length: Canceled: DIN EN 10220: EN 10220: DIN 2527: Blank flanges – Nominal pressure 6 to 100: Withdrawn: DIN EN 1092-1: EN 1092-1: DIN 2860: Capillary Fittings; Bends 180° of Copper: Withdrawn: DIN 2982: Steel threaded pipe fittings: Withdrawn: DIN EN 10241: EN ...

  8. Pipe (fluid conveyance) - Wikipedia

    en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

    Since the outside diameter is fixed for a given pipe size, the inside diameter will vary depending on the wall thickness of the pipe. For example, 2" Schedule 80 pipe has thicker walls and therefore a smaller inside diameter than 2" Schedule 40 pipe. Steel pipe has been produced for about 150 years.

  9. Birmingham gauge - Wikipedia

    en.wikipedia.org/wiki/Birmingham_gauge

    The Birmingham gauge is also known as the Stubs Iron Wire Gauge or Birmingham Wire Gauge and is distinct from the Stubs Steel Wire Gauge and the British Standard Wire Gauge. It is commonly referred to simply as gauge (abbreviated as G ), [ 3 ] but this should not be confused with the French gauge , a separate system used for measuring the outer ...

  1. Ad

    related to: material thickness gauge chart for steel pipe specifications pdf full screen