Search results
Results from the WOW.Com Content Network
The entrenching tool helve and bayonet scabbard can also be seen. The 1908 equipment, when fully assembled, formed a single piece, and could be put on or taken off like a jacket. Ammunition was stored in two sets of pouches attached to the belt at the front, and the straps from these passed over the shoulders, crossing diagonally at the back.
Henry V. Allien & Company submitted five pattern swords for the uniform board's consideration, three with straight blades and two with curved, and the Ordnance Department submitted a similar number. The result was that of the ten patterns, one of the Allien swords was adopted, the very one approved by General Kelton.
The M1905 bayonet had a tendency to rattle inside the scabbard, and so ribs were molded into the scabbard tip to hold the blade. When production of the M1 bayonet began in 1943, a new scabbard, the M7 (otherwise identical in construction to the M3) was developed that used spring steel plates in the scabbard throat to hold the blade instead of ...
The U.S. Model 1840 light artillery saber has a brass hilt and knuckle-bow of about 6 inches in length, the grip wrapped in leather and bound with brass wire, and a blade of 32.25 inches in length.
Scabbard and Blade was a college military honor society founded at the University of Wisconsin in 1904. Following is a list of the Scabbard and Blade chapters or companies [ 1 ] [ 2 ] [ 3 ] Regiment
A scabbard is a sheath for holding a sword, dagger, knife, or similar edged weapons. Rifles and other long guns may also be stored in scabbards by horse riders for transportation. Military cavalry and cowboys had scabbards for their saddle ring carbines and rifles for transportation and protection.
As a dress sword, it is of relatively lightweight construction. The weight of the sword is about 1 lb 10.5 oz (750 g) and the scabbard about 1 lb 1 oz (480 g). [6] The 31 inch-long (79 cm) blade is slab-sided and of a V-shaped cross-section, it is double-edged for its last 12 inches (the yelman) and comes to a relatively acute asymmetric point ...
The design was influenced by the French heavy cavalry sword of the Napoleonic Wars, [clarification needed] as well as French cavalry doctrine that emphasized the use of the point over the edge [5] and is similar to the French Mle 1896 straight saber (and the previous Mle 1882), with which French cavalry entered the World War I, and the British Pattern 1908 and 1912 cavalry swords.