Search results
Results from the WOW.Com Content Network
The cast restricts ankle movement while allowing knee mobility. In some cases, a toe plate is added to a short leg cast to provide additional protection for toe injuries or fractures. The toe plate is an extension of the cast that covers the toes, shielding them from external forces and reducing the risk of further injury during recovery.
Cast-in-place concrete or Cast-in-situ concrete is a technology of construction of buildings where walls and slabs of the buildings are cast at the site in formwork. [1] This differs from precast concrete technology where slabs are cast elsewhere and then brought to the construction site and assembled. [ 2 ]
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel-reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving (see below). [1] [2]
Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...
Tilt-up, tilt-slab or tilt-wall is a type of building and a construction technique using concrete. Though it is a cost-effective technique with a shorter completion time, [ 1 ] poor performance in earthquakes has mandated significant seismic retrofit requirements in older buildings.
Prefabricated slabs also have the advantage of a smooth underside suitable for use as a ceiling without further finishing. Varying degrees of prefabrication are available, including entire slabs. [1] Prefabricated modules commonly consist of a fully cast piece of slab, including all components encased in concrete.
The slab is created directly by continuous casting or indirectly by rolling an ingot on a slabbing mill. [1] Slabs are usually further processed via flat rolling, skelping, and pipe rolling. Common final products include sheet metal, plates, strip metal, pipes, and tubes. [3] Slab are mainly produced through blast furnace route. One of the ...
This reduces the labor cost and time typically required to grind and patch the soffits of cast-in-place concrete decks to achieve an acceptable aesthetic finish. The method of deck construction can be applied anywhere conventionally poured-in-place concrete is specified, such as flat plate, beam and slab, and wall-bearing structures.