Search results
Results from the WOW.Com Content Network
Many pieces of amateur radio equipment run on 12-volt DC automotive voltage, which is also called 13.8-volt DC. The voltage delivered by a lead–acid battery with six-cells used as an automotive battery will vary depending on various electrical loads in a vehicle. Without loads the battery will float from 11.7 to 12.8 volts, and while charging ...
The maximum transmission distance is depending on the bit rate and the quality of the cable. RG-11, RG-6, RG-59, and other cable types can be used. It is also possible to reuse existing coaxial cable when upgrading from an analogue to a digital camera system. The original connector for CoaXPress is a 75 Ω IEC 61169-8 BNC connector.
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
HDBaseT connectors at a presentation and collaboration system from WolfVision. HDBaseT is a consumer electronic (CE) and commercial connectivity standard for transmission of uncompressed ultra-high-definition video, digital audio, DC power, Ethernet, USB 2.0, and other control communication (such as RS-232 and Consumer IR) over a single category cable (Cat 5e or better) up to 100 m (328 ft) in ...
Attachments (additional files, such as fonts for subtitles) are only supported in Matroska, [41] MP4 and QTFF. M2TS supports attachments as multiple files in a specific file structure: fonts for subtitles are in .otf files in the /BDMV/AUXDATA/ directory. Interactive menus are only supported in MP4, QTFF, M2TS, EVO and DMF.
These standards allow a maximum pixel clock of 112 MHz, which suffices for a display resolution of 1400 × 1050 at 60 Hz refresh. A dual link can boost the maximum display resolution to 2048 × 1536 at 60 Hz. FPD-Link works with cable lengths up to about 5 m, and LDI extends this to about 10 m.
DisplayPort cables up to 2 meters in length are required to support the full 10.8 Gbit/s bandwidth. [8] DisplayPort 1.1 allows devices to implement alternative link layers such as fiber optic , allowing a much longer reach between source and display without signal degradation, [ 9 ] although alternative implementations are not standardized.
However, most other coaxial DC power connectors have no specified voltage association. Generic plugs are often named for the pin diameter they are designed to take. Many non-proprietary co-axial power plugs are 5.5 mm (0.22 in) in outside diameter (OD) and 9.5 mm (0.37 in) in length. Two pin sizes are standard in the jacks for this size plug ...