Search results
Results from the WOW.Com Content Network
After inserting the known value for each degree of freedom, the master stiffness equation is complete and ready to be evaluated. There are several different methods available for evaluating a matrix equation including but not limited to Cholesky decomposition and the brute force evaluation of systems of equations. If a structure isn’t ...
In this case, the two unknowns V A and V C can be determined by resolving the vertical force equation and the moment equation simultaneously. The solution yields the same results as previously obtained. However, it is not possible to satisfy the horizontal force equation unless F h = 0. [2]
When =, the truss is said to be statically determinate, because the (m+3) internal member forces and support reactions can then be completely determined by 2j equilibrium equations, once we know the external loads and the geometry of the truss. Given a certain number of joints, this is the minimum number of members, in the sense that if any ...
In physics and engineering, a free body diagram (FBD; also called a force diagram) [1] is a graphical illustration used to visualize the applied forces, moments, and resulting reactions on a free body in a given condition. It depicts a body or connected bodies with all the applied forces and moments, and reactions, which act on the body(ies).
An influence line for a given function, such as a reaction, axial force, shear force, or bending moment, is a graph that shows the variation of that function at any given point on a structure due to the application of a unit load at any point on the structure. An influence line for a function differs from a shear, axial, or bending moment diagram.
The equations are written only for the small domain of individual elements of the structure rather than a single equation that describes the response of the system as a whole (a continuum). The latter would result in an intractable problem, hence the utility of the finite element method.
The external body forces will appear as the independent ("right-hand side") term in the differential equations, while the concentrated forces appear as boundary conditions. An external (applied) surface force, such as ambient pressure or friction, can be incorporated as an imposed value of the stress tensor across that surface.
Stress resultants are simplified representations of the stress state in structural elements such as beams, plates, or shells. [1] The geometry of typical structural elements allows the internal stress state to be simplified because of the existence of a "thickness'" direction in which the size of the element is much smaller than in other directions.