enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

3. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The history of copper pipe is similar. In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings.

4. Polyvinyl chloride - Wikipedia

   en.wikipedia.org/wiki/Polyvinyl_chloride

   [37] [38] Buried PVC pipes in both water and sanitary sewer applications that are 100 mm (4 in) in diameter and larger are typically joined by means of a gasket-sealed joint. The most common type of gasket utilized in North America is a metal-reinforced elastomer, commonly referred to as a Rieber sealing system.

5. Friction loss - Wikipedia

   en.wikipedia.org/wiki/Friction_loss

   The entire dependence of f D on the pipe diameter D is subsumed into the Reynolds number Re ... (300 mm) Schedule-40 PVC pipe (ε = 0.0015 mm, D = 11.938 in.), a ...

6. Talk:Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Talk:Nominal_Pipe_Size

   Copper pipe in the US at least, comes in different thickesses, and the outside diameter is based on the nominal size plus 1/8". That is, 1/2" copper plumbing pipe (not refrigeration tubing) is exactly 5/8" outside diameter. There is also standard for PVC pipe below schedule 40, for irrigation use called PS125 or something like that.

7. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ⁄ 4 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread. The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′.