Search results
Results from the WOW.Com Content Network
Shrinkage and Contraction can again be classified into liquid shrinkage and solid contraction. Liquid shrinkage is the reduction in volume during the process of solidification (liquid to solid), the liquid shrinkage is accounted for by risers. Solid contraction is the reduction in dimensions during the cooling of the (solid) cast metal.
Heat-setting of synthetic fabrics eliminates the internal tensions within the fiber, generated during manufacturing, and the new state can be fixed by rapid cooling. This heat setting fixes the fabrics in the relaxed state, and thus avoids subsequent shrinkage or creasing of the fabric.
Directional solidification can be used as a purification process. Since most impurities will be more soluble in the liquid than in the solid phase during solidification, impurities will be "pushed" by the solidification front, causing much of the finished casting to have a lower concentration of impurities than the feedstock material, while the ...
Solidification shrinkage occurs because metals are less dense as a liquid than a solid, so during solidification the metal density dramatically increases. Patternmaker's shrinkage refers to the shrinkage that occurs when the material is cooled from the solidification temperature to room temperature, which occurs due to thermal contraction. [20]
A bronze casting showing the sprue and risers. A riser, also known as a feeder, [1] is a reservoir built into a metal casting mold to prevent cavities due to shrinkage.Most metals are less dense as a liquid than as a solid so castings shrink upon cooling, which can leave a void at the last point to solidify.
Curing is a chemical process employed in polymer chemistry and process engineering that produces the toughening or hardening of a polymer material by cross-linking of polymer chains. [1] Even if it is strongly associated with the production of thermosetting polymers , the term "curing" can be used for all the processes where a solid product is ...
The formulation of fabric treatment composition is that in a 1.5 litre beaker, 219.8 g in distilled water, 287.9 ml is polyethylene glycol, 100 ml is 2-ethanol and the mixture is heated to 85 degrees Celsius. 120 ml of sodium stearate is added during the heating process.
The depth of the mold can range from 0.5 to 2 metres (20 to 79 in), depending on the casting speed and section size. The mold is water-cooled to solidify the hot metal directly in contact with it; this is the primary cooling process. It also oscillates vertically (or in a near vertical curved path) to prevent the metal sticking to the mold walls.