Search results
Results from the WOW.Com Content Network
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.
The timing marks can be used to set the ignition timing either statically by hand or dynamically using a timing light, by rotating the distributor in its seat. In a multi-cylinder engine, pistons may reach top dead centre simultaneously or at different times depending on the engine configuration .
If the characteristic pressure peak of a knocking combustion is detected the ignition timing is retarded by steps of a few degrees. If the signal normalizes indicating a controlled combustion the ignition timing is advanced again in the same fashion keeping the engine at its best possible operating point - the so-called ″knock limit″.
However, in 1990 Honda set the crankpin phases of each pair of pistons within each bank to be the same (like a four-stroke "droner": 360° crank), but with each bank's crankpins offset by 180° to each other (effectively "splitting" the pins and changing the V-angle, in terms of ignition timing). This was called a "big bang" engine.
In an external combustion engine, such as a steam engine, the control of the valve timing is by the valve gear. In a typical piston valve arrangement, the timing of the intake and exhaust events for each cylinder are inextricably related as they are governed by the movement of a single piston uncovering two ports. However, the duration of the ...
Timing light, combination instrument with RPM, volt meter and dwell angle meter. The actual light is on the far end. The black clamp connects to the battery -, the red clamp to +, the green one to the breaker side of the coil (for RPM), the big black clamp in the foreground is an inductive pick-up that clamps around a spark plug wire.
Maximum brake torque (MBT) is the use of optimal ignition timing to take advantage of an internal combustion engine's maximum power and efficiency. There is always an optimal spark timing for all operating conditions of an engine. MBT is ideal at wide-open throttle (WOT), but not desirable when the engine is at idle.