enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plywood - Wikipedia

   en.wikipedia.org/wiki/Plywood

   Aircraft plywood is available in thicknesses of 1 ⁄ 8 inch (3 mm) (3-ply construction) and upwards; typically aircraft plywood uses veneers of 0.5 mm (approx 1/64 in) thickness although much thinner veneers such as 0.1 mm are also used in construction of some of the thinner panels.

3. Floor - Wikipedia

   en.wikipedia.org/wiki/Floor

   The two layers in high-quality construction will both be thick 3 ⁄ 4 inch (19.1 mm) sheets (as will the third when present), but they may have a combined thickness of only half that in cheaper construction – 1 ⁄ 2 in (12.7 mm) panel overlaid by 1 ⁄ 4 in (6.4 mm) plywood subflooring. At the highest end, or in select rooms of the building ...

4. Engineered wood - Wikipedia

   en.wikipedia.org/wiki/Engineered_wood

   Plywood and OSB typically have a density of 560–640 kg/m 3 (35–40 lb/cu ft). For example, 9.5 mm (3 ⁄ 8 in) plywood sheathing or OSB sheathing typically has a surface density of 4.9–5.9 kg/m 2 (1–1.2 lb/sq ft). [51] Many other engineered woods have densities much higher than OSB.

5. Medium density overlay panel - Wikipedia

   en.wikipedia.org/wiki/Medium_density_overlay_panel

   Medium density overlay panel, or MDO panel, is a paintable surface made of plywood with a weather-resistant resin overlay bonded to the wood by heat and pressure. The overlay, which has at least 27% resin content, [1] resists water, weather, wear and degradation. A similar product with a more rugged, smoother surface is called high density ...

6. Oriented strand board - Wikipedia

   en.wikipedia.org/wiki/Oriented_strand_board

   The number of layers placed is determined partly by the thickness of the panel, but is limited by the equipment installed at the manufacturing site. Individual layers can also vary in thickness to give different finished panel thicknesses; typically, a 15 cm (5.9 in) layer will produce a 15 mm (0.59 in) panel thickness [ citation needed ] .

7. BS 1088 - Wikipedia

   en.wikipedia.org/wiki/BS_1088

   Face Veneer thickness-- For any three-ply construction, which applies to 3 and 4 mm material, each face veneer shall be not thinner than 1/8 of the total thickness of veneers assembled dry. Since the dry thicknesses of the boards are 3.6 and 4.6 respectively, we can assume that, for these thicknesses only, the face veneers will be as follows:

8. List of building materials - Wikipedia

   en.wikipedia.org/wiki/List_of_building_materials

   Sheathing, subflooring, panelling. Plywood, shiplap, tongue and groove; Oriented strand board; Parallel strand lumber or "PSL" Glued laminated timber or "glulam" Finish carpentry or "architectural woodwork" Veneer, plastic laminate, wood panel; Case-building products Millwork, bookcase, cabinets; Ornamental woodwork; Trim, molding or "moulding"

9. Wood flooring - Wikipedia

   en.wikipedia.org/wiki/Wood_flooring

   Birch plywood is commonly used as the substrate in engineered flooring due to its strength, durability, and waterproof properties. It is composed of several thin layers of birch veneer core glued together. It is well-suited for commercial vehicle flooring and trailer decking for its flexibility and ability to endure heavy foot traffic. [5]