enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Process duct work may be round or rectangular. Although round duct work costs more to fabricate than rectangular duct work, it requires fewer stiffeners and is favored in many applications over rectangular ductwork. The air in process duct work may be at ambient conditions or may operate at up to 900 °F (482 °C).

3. Hydraulic diameter - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_diameter

   For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, then D H = 2a. Channel of water or partially filled rectangular duct. Open from top by definition so that the wetted perimeter consists of the 3 sides of the duct (2 on the side and the base). = +

4. Diffuser (thermodynamics) - Wikipedia

   en.wikipedia.org/wiki/Diffuser_(thermodynamics)

   Ducts containing fluids flowing at low velocity can usually be analyzed using Bernoulli's principle. Analyzing ducts flowing at higher velocities with Mach numbers in excess of 0.3 usually require compressible flow relations. [2] A typical subsonic diffuser is a duct that increases in area in the direction of flow. As the area increases, fluid ...

5. Entrance length (fluid dynamics) - Wikipedia

   en.wikipedia.org/wiki/Entrance_length_(fluid...

   In fluid dynamics, the entrance length is the distance a flow travels after entering a pipe before the flow becomes fully developed. [1] Entrance length refers to the length of the entry region, the area following the pipe entrance where effects originating from the interior wall of the pipe propagate into the flow as an expanding boundary layer.

6. Engineering fit - Wikipedia

   en.wikipedia.org/wiki/Engineering_fit

   Engineering fits are generally used as part of geometric dimensioning and tolerancing when a part or assembly is designed. In engineering terms, the "fit" is the clearance between two mating parts, and the size of this clearance determines whether the parts can, at one end of the spectrum, move or rotate independently from each other or, at the other end, are temporarily or permanently joined.

7. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Round duct is made using a continuous spiral forming machine which can make round duct in nearly any diameter when using the right forming die and to any length to suit, but the most common stock sizes range evenly from 4" to 24" (10-60 cm) with 6"-12" (15-30 cm) being most commonly used. Stock pipe is usually sold in 10' (300 cm) joints.