Search results
Results from the WOW.Com Content Network
The millimetre (SI symbol: mm) is a unit of length in the metric system equal to 10 −3 metres ( 1 / 1 000 m = 0.001 m). To help compare different orders of magnitude , this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm).
For instance the same angle of 0.1 mrad will subtend 10 mm at 100 meters, 20 mm at 200 meters, etc., or similarly 0.39 inches at 100 m, 0.78 inches at 200 m, etc. Subtensions in mrad based optics are particularly useful together with target sizes and shooting distances in metric units .
Values of 0.030 mm and 0.033 mm are also common for full-frame 35 mm format. Criteria relating CoC to the lens focal length have also been used. Kodak recommended 2 minutes of arc (the Snellen criterion of 30 cycles/degree for normal vision) for critical viewing, yielding a CoC of about f /1720, where f is the lens focal length. [ 8 ]
The bar is a metric unit of pressure defined as 100,000 Pa (100 kPa), though not part of the International System of Units (SI). A pressure of 1 bar is slightly less than the current average atmospheric pressure on Earth at sea level (approximately 1.013 bar).
The .308 Winchester is measured across the grooves and uses a .308-in diameter (7.82-mm) bullet; the military-specification version is known as 7.62 × 51 mm NATO, so called because the bore diameter measured between the lands is 7.62 mm, and the cartridge has a case 51 mm long.
From 1.0 through 2.95 mm, sizes are defined as follows, where N is an integer from 10 through 29: N · 0.1 mm; N · 0.1 + 0.05 mm; From 3.0 through 13.9 mm, sizes are defined as follows, where N is an integer from 30 through 139: N · 0.1 mm; From 14.0 through 25.0 mm, sizes are defined as follows, where M is an integer from 14 through 25: M ...
A metric ounce is an approximation of the imperial ounce, US dry ounce, or US fluid ounce. These three customary units vary. However, the metric ounce is usually taken as 25 or 30 ml (0.88 or 1.06 imp fl oz; 0.85 or 1.01 US fl oz) when volume is being measured, or in grams when mass is being measured.
For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation of 0.036 mm) and the hole might be specified with a tolerance range from 10.04 mm to 10.076 mm (0.04 mm fundamental ...