Search results
Results from the WOW.Com Content Network
Though the total particulate emissions from wet cooling towers with fresh water make-up is much less, they contain more PM 10 and PM 2.5 than the total emissions from wet cooling towers with sea water make-up. This is due to lesser salt content in fresh water drift (below 2,000 ppm) compared to the salt content of sea water drift (60,000 ppm).
The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.
ANSI/ASHRAE Standard 55: Thermal Environmental Conditions for Human Occupancy is an American National Standard published by ASHRAE that establishes the ranges of indoor environmental conditions to achieve acceptable thermal comfort for occupants of buildings. It was first published in 1966, and since 2004 has been updated every three to six years.
Depiction of New York World Building fire in New York City in 1882. Building codes in the United States are a collection of regulations and laws adopted by state and local jurisdictions that set “minimum requirements for how structural systems, plumbing, heating, ventilation, and air conditioning (), natural gas systems and other aspects of residential and commercial buildings should be ...
The cooling towers of a large chilled water system. As part of a chilled water system, the condenser water absorbs heat from the refrigerant in the condenser barrel of the water chiller and is then sent via return lines to a cooling tower , which is a heat exchange device used to transfer waste heat to the atmosphere .
Wet cooling towers operate on the evaporative cooling principle, but are optimized to cool the water rather than the air. Cooling towers can often be found on large buildings or on industrial sites. They transfer heat to the environment from chillers, industrial processes, or the Rankine power cycle , for example.
Deep water source cooling (DWSC) or deep water air cooling is a form of air cooling for process and comfort space cooling which uses a large body of naturally cold water as a heat sink. It uses water at 4 to 10 degrees Celsius drawn from deep areas within lakes, oceans, aquifers or rivers, which is pumped through the one side of a heat exchanger .
The standard would also apply to additions to existing buildings and their systems as well as alterations to an existing buildings system. For ASHRAE 90.1 standard to apply to the building envelope the building will need to be heated by a heating system that has an output capacity greater than 3.4 btu/h-ft2 or be cooled by a cooling system that ...