Search results
Results from the WOW.Com Content Network
Diagram showing lap and lead and their relation to valve travel. When on the move, a steam locomotive requires steam to enter the cylinder at precise times relative to the piston's position. [3] This entails controlling the admission and exhaust of steam to and from the cylinders with a valve linked to the motion of the piston. [3]
In the simple case, this can be a relatively simple task as in the internal combustion engine in which the valves always open and close at the same points. This is not the ideal arrangement for a steam engine, though, because greatest power is achieved by keeping the inlet valve open throughout the power stroke (thus having full boiler pressure, minus transmission losses, against the piston ...
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
Double-beat poppet valves became widely used during the nineteenth century. Francis Stevens invented the Stevens valve gear, a double beat poppet valve, in 1839. It was used throughout the nineteenth century and in the early years of the 20th, on side-wheel paddle steamer engines, including the grasshopper engine, in the United States. [4]
During the 1830s, the most popular valve drive for steam locomotives was known as gab motion in the United Kingdom and V-hook motion in the United States. [3] The gab motion incorporated two sets of eccentrics and rods for each cylinder; one eccentric was set to give forward and the other backwards motion to the engine and one or the other could accordingly engage with a pin driving the ...
Hackworth valve gear on steam locomotive ' Lydia ' at the Perrygrove Railway. Hackworth valve gear on Apedale Valley Light Railway locomotive ' Stanhope ' Hackworth valve gear on Tal-y-Llyn Railway locomotive ' Edward Thomas ' The Hackworth valve gear is a design of valve gear used to regulate the flow of steam to the pistons in steam engines.
Indicator diagram showing steam pressure with piston movement. An expansion valve is a secondary valve within a steam engine. They represent an intermediate step between steam engines with non-expansive working and later valve gears that could provide for expansion by controlling the motion of a single valve.
In the 19th century, most steam locomotives used slide valves to control the flow of steam into and out of the cylinders. In the 20th century, slide valves were gradually superseded by piston valves, particularly in engines using superheated steam. There were two reasons for this: With piston valves, the steam passages can be made shorter.