Search results
Results from the WOW.Com Content Network
Corner blocks are used to join the corners of a soft-cover flat. They are normally made of 1 ⁄ 4 -inch (6.4 mm) plywood, and are triangles with corners of 45°, 45°, and 90°. They are most often made by ripping the plywood at 6 + 1 ⁄ 2 inches (170 mm) and then mitering it at 45 degree angles to create triangles with 9-inch (230 mm) legs.
In plumbing, the term "45-degree elbow" for example, refers to the angle of bend from the original straight pipe position (0 degrees) to the new position (45 degrees), not the actual angle formed by the joint. On a protractor, the actual angle of the above joint is 135 degrees, an obtuse angle.
A screw is then inserted through an opposing slot and tightened to create a pull effect. This type of join is a very common joint in factory-made furniture. Mitre joint: Similar to a butt joint, but both pieces have been beveled (usually at a 45-degree angle). Box joint: A corner joint with interlocking square fingers.
Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.
The angle of slope varies according to the wood used, purpose of joint and type of work. Typically the slope is 1:6 for softwoods, and a shallower 1:8 slope for hardwoods. Often a slope of 1:7 is used as a compromise. However, a different slope does not affect the strength of the joint in different types of wood. [4]
Stretch out left arm and leg to the side at a 45-degree angle. With a good grip on the weight, press it up toward ceiling, straightening your right arm completely and keeping gaze on the weight.
From here, raise the right leg to a 90 degree angle, keeping the stationary leg firmly on the ground and pelvis stable. Return right foot to meet left foot in starting position. That’s 1 rep.
An A-frame is a basic structure designed to bear a load in a lightweight economical manner. The simplest form of an A-frame is two similarly sized beams , arranged in an angle of 45 degrees or less, attached at the top, like an uppercase letter 'A'.