Search results
Results from the WOW.Com Content Network
A sample CG-moment envelope chart, showing that a loaded plane weighing 2,367 lb (1,074 kg) with a moment of 105,200 lb⋅in (11886 N⋅m) is within the "normal category" envelope. Center of gravity (CG) is calculated as follows: Determine weights and arms for all mass within the aircraft. Multiply weights by arms for all mass to calculate moments.
Yawing also increases the speed of the outboard wing whilst slowing down the inboard wing, with corresponding changes in drag causing a (small) opposing yaw moment. N r {\displaystyle N_{r}} opposes the inherent directional stiffness which tends to point the aircraft's nose back into the wind and always matches the sign of the yaw rate input.
At the opposite end of the spectrum was the large Convair B-36: its large wings resulted in a low 269 kg/m 2 (55 lb/sq ft) wing loading that could make it sustain tighter turns at high altitude than contemporary jet fighters, while the slightly later Hawker Hunter had a similar wing loading of 344 kg/m 2 (70 lb/sq ft).
In the definition of load factor, the lift is not simply that one generated by the aircraft's wing, instead it is the vector sum of the lift generated by the wing, the fuselage and the tailplane, [2]: 395 or in other words it is the component perpendicular to the airflow of the sum of all aerodynamic forces acting on the aircraft.
Mean aerodynamic chord (MAC) is defined as: [6] = (), where y is the coordinate along the wing span and c is the chord at the coordinate y.Other terms are as for SMC. The MAC is a two-dimensional representation of the whole wing. The pressure distribution over the entire wing can be reduced to a single lift force
The KF airfoil was designed by Richard Kline and Floyd Fogleman. Aircraft wing showing the KFm4 Step. In the early 1960s, Richard Kline wanted to make a paper airplane that could handle strong winds, climb high, level off by itself and then enter a long downwards glide.
A straight-winged North American FJ-1 flying next to a swept-wing FJ-2 in 1952.. There are three main reasons for sweeping a wing: [1] 1. to arrange the center of gravity of the aircraft and the aerodynamic center of the wing to coincide more closely for longitudinal balance, e.g. Messerschmitt Me 163 Komet and Messerschmitt Me 262.
An elliptical wing is a wing planform whose leading and trailing edges each approximate two segments of an ellipse. It is not to be confused with annular wings , which may be elliptically shaped. Relatively few aircraft have adopted the elliptical wing, an even-smaller number of which attained mass production ; the majority of aircraft that did ...