Search results
Results from the WOW.Com Content Network
Sodium hypochlorite can also be used for point-of-use disinfection of drinking water, [40] taking 0.2–2 mg of sodium hypochlorite per liter of water. [41] Dilute solutions (50 ppm to 1.5%) are found in disinfecting sprays and wipes used on hard surfaces. [42] [43]
For example, in the 1930s Widmark measured alcohol and blood by mass, and thus reported his concentrations in units of g/kg or mg/g, weight alcohol per weight blood. Blood is denser than water and 1 mL of blood has a mass of approximately 1.055 grams, thus a mass-volume BAC of 1 g/L corresponds to a mass-mass BAC of 0.948 mg/g.
For instance, if the ADI is based on data from humans the safety factor is usually 10 instead of 100. The ADI is usually given in mg per kg body weight. [5] The ADI is considered a safe intake level for a healthy adult of normal weight who consumes an average daily amount of the substance in question.
Change in volume with increasing alc/vol. Mixing two solutions of alcohol of different strengths usually causes a change in volume. Mixing pure water with a solution less than 24% by mass causes a slight increase in total volume, whereas the mixing of two solutions above 24% causes a decrease in volume.
At 100 °C (212 °F; 373 K), saturated sodium chloride brine is about 28% salt by weight. At 0 °C (32 °F; 273 K), brine can only hold about 26% salt. [ 3 ] At 20 °C one liter of water can dissolve about 357 grams of salt, a concentration of 26.3%.
For strong electrolytes, such as salts, strong acids and strong bases, the molar conductivity depends only weakly on concentration. On dilution there is a regular increase in the molar conductivity of strong electrolyte, due to the decrease in solute–solute interaction. Based on experimental data Friedrich Kohlrausch (around the year 1900 ...
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
Sodium dodecyl sulfate (SDS) or sodium lauryl sulfate (SLS), sometimes written sodium laurilsulfate, is an organic compound with the formula CH 3 (CH 2) 11 OSO 3 Na and structure H 3 C−(CH 2) 11 −O−S(=O) 2 −O − Na +. It is an anionic surfactant used in many cleaning and hygiene products. This compound is the sodium salt of the 12 ...