Search results
Results from the WOW.Com Content Network
The British, European and International standard for hot-dip galvanizing is BS EN ISO 1461, which specifies a minimum coating thickness to be applied to steel in relation to the steels section thickness e.g. a steel fabrication with a section size thicker than 6 mm shall have a minimum galvanized coating thickness of 85 μm.
EN 14: Dimensions of bed blankets; EN 19: Industrial valves – Marking of metallic valves; EN 20: Wood preservatives. EN 26: Gas-fired instantaneous water heaters for the production of domestic hot water; EN 40-1: Lighting columns - Part 1: Definitions and terms; EN 40-2: Lighting columns - Part 2: General requirements and dimensions
Regular ferrous alloys are the most common due to price and availability. Common sizes of corrugated material can range from a very thin 30 gauge (0.012 inches, 0.3 mm) to a relatively thick 6 gauge (0.1943 inches, 5 mm). Thicker or thinner gauges may also be produced.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
BS 86 Report on Dimensions of Magnetos for Aircraft Purposes; BS 87 Report on Dimensions for Airscrew Hubs; BS 88 Specification for cartridge fuses for voltages up to and including 1000 V a.c. and 1500 V d.c. Originally titled: “Specification for Electric Cut-Outs (Low Pressure, Type O)”
BS 2 Specification and sections of tramway rails and fishplates; BS 3 Report on influence of gauge length and section of test bar on the percentage of elongation; BS 4 Specification for structural steel sections; BS 5 Report on locomotives for Indian railways; BS 7 Dimensions of copper conductors insulated annealled, for electric power and light
This specification covers seamless and welded black and hot-dipped galvanized steel pipe in NPS 1⁄8 to NPS 26 [DN 6 to DN 650] (Note 1), inclusive, with nominal wall thickness (Note 2) as given in Table X2.2 and Table X2.3.
EN 545/598 mandates a minimum zinc content of 200 g/m 2 (at 99.99% purity) and a minimum average finishing layer thickness of 70 μm (with local minimum of 50 μm). AS/NZS 2280 mandates a minimum zinc content of 200 g/m 2 (with a local minimum of 180 g/m 2 at 99.99% purity) and a minimum average finishing layer thickness of 80 μm.