Search results
Results from the WOW.Com Content Network
Re: deer blind plans - 01/20/11 03:49 AM. Hey, anyone seen the stands at: www.realbark.com. You can get it with a ladder or stairs and 5' high or 10' high. a 4', 5', or 6' dia. stand. They say that they are UV proof and they last 15 years, said some they sold in 1990 are still as good as new.
I would assume weight and cost. And to cut cost even more, a 2x4 can be ripped down the middle to make 2x2s. My BIL's stand is 2x2s and its plenty sturdy 6' off the ground. Re: deer blind plans [Re: hotrod3367] #6169399 02/04/16 04:26 PM. Joined: May 2014. Posts: 374. Granbury, TX (Hood County) S. StretchR.
Re: DIY DEER BLIND PLANS.... POST WHAT YOU HAVE [Re: hotrod3367] #2462769 07/29/11 03:21 AM. Here is my new 4' x 8' deer stand I set up for hunting in the tall timber of East Texas. It was built by students within the Department of Agriculture at Texas State University for the cost of materials.
Cut the 1x4's the same width as the side, but stagger them by the width of the 1x4. This way you can carry the panels to the field and "Lock the sides together". If you predrill the holes at home, all you have to do is insert a lag bolt in the center of the 1x4's where they overlap. Can assemble the entire deer blind by your self.
To frame all the walls, visualize a second 2"x2" next to the ones on the front and back walls. The cross-pieces would be between those. PM your email and I will send you the PDF that has the drawings, materials, instructions, and some more photos. Re: deer blind plans [Re: hotrod3367] #6684528 02/23/17 05:38 AM.
Posts: 179. Dallas, TX. I am building a deer blind and want to make sure I do not cut the windows to high or low. I measured and it looks like for me a 6 ft tall male the bottm ht should be about 38 -39 inches from the bottom. It just looks very odd since I havve no windows at all. any feed back.
Drill holes through and use bolts to hold it all in place. This is how my cleaning racks and feeders are all built and allways will be. a little hard to find 2.5" at times but I bought one stick (22') and still have a little left over for the nexy one I build. Works like a champ. Texas Elite Outfitters. 281-924-9720.
Posts: 350. Melissa, TX. Camo job on blind is after an OD base which takes about 1.5 gal of primer/paint mix. Then it's using cans of various colors of the camo. Just spray in circles with the various colors and eventually you'll get it right or run out of money. Always get the wife to supervise with a critical eye.
5x5 is a nice stand size especially for one person. If you do the math, you actually get more square feet out of that than a 4x6. One of the problems is buying the material, which normally comes in 4x8 sheets, unless that is you go metal and can get it in that size. Re: 5x5 stand [Re: Southtexas36] #3525837 08/30/12 12:46 AM.
Tie a piece of 1/2" +/- rope to the middle of the bottom of the stand and then to the top of the anchor. Screw the anchor again until it's tight. If it loosens through the year just a quick turn tightens it again. Nylon rope stretches some and helps keep tension. Do not use any of the "poly" ropes.