enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wall stud - Wikipedia

   en.wikipedia.org/wiki/Wall_stud

   Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.

3. Blocking (construction) - Wikipedia

   en.wikipedia.org/wiki/Blocking_(construction)

   When correctly placed, blocking also provides grounds (also backing or back blocking) for supporting the cut ends of wall claddings and linings or for attaching items such as cabinets, shelving, handrails, vanity tops and backsplashes, towel bars, decorative mouldings, etc. Properly placed grounds make the second fixings easier once the walls ...

4. Toenailing - Wikipedia

   en.wikipedia.org/wiki/Toenailing

   Example of toenailing in stud framing. Toenailing or skew-nailing is a viable, structurally sound method [1] of the driving of a nail at a roughly 30° [2] angle to fasten two pieces of wood together, typically with their grains perpendicular. The term comes colloquially from fastening wood at the bottom, or toe, of the board.

5. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

6. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   The broad end of the pin is slightly wider than the hole of the nail-header: the smith fits the pin into the hole of the nail-header and then hammers the broad end of the pin. Unable to advance through the hole, the broad end is flattened against the nail-header to create a nail-head.

7. Butt joint - Wikipedia

   en.wikipedia.org/wiki/Butt_joint

   This method is preferred when the edges of the frame will be visible. The pocket holes require two drilling operations to be completed. The first is to counterbore the pocket hole itself, which houses the screw head within the member. This hole is stopped 1 ⁄ 4 in (6.4 mm) or so from the edge of the frame member. The second step is to drill a ...

8. Glossary of woodworking - Wikipedia

   en.wikipedia.org/wiki/Glossary_of_woodworking

   The frame or main parts of an unfinished workpiece before they are completed with coverings. card scraper A flat blade with a burred edge used for smoothing. carpentry caul A strip or block of wood used to distribute or direct clamping force. See batten. chainsaw chamfer chatoyance

9. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Machine screws are also made with socket heads (see above), in which case they may be referred to as socket head machine screws. stove bolt: gutter bolt: A Stove bolt is a type of machine screw that has a round or flat head and is threaded to the head. They are usually made of low grade steel, have a slot or Phillips drive, and are used to join ...