Search results
Results from the WOW.Com Content Network
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
A related-but-opposite technique is overclocking, whereby processor performance is increased by ramping the processor's (dynamic) frequency beyond the manufacturer's design specifications. One major difference between the two is that in modern PC systems overclocking is mostly done over the Front Side Bus (mainly because the multiplier is ...
Moreover, for a given noise power spectral density (PSD), spread-spectrum systems require the same amount of energy per bit before spreading as narrowband systems and therefore the same amount of power if the bitrate before spreading is the same, but since the signal power is spread over a large bandwidth, the signal PSD is much lower — often ...
Overclocking is the process of forcing your computer to run faster than it's intended to go, which can help you run advanced programs on an older PC. Overclocking is the process of forcing your ...
The application will support all members of the AMD 700 chipset series, including the 740 series chipsets which are aimed at value markets, and AMD processors including Phenom and Athlon 64 family of processors, but due to architectural limitations, independent clock frequency settings for different processor cores (a feature implemented in the ...
APM defines five power states for the computer system: Full On: The computer is powered on, and no devices are in a power saving mode. APM Enabled: The computer is powered on, and APM is controlling device power management as needed. APM Standby: Most devices are in their low-power state, the CPU is slowed or stopped, and the system state is saved.
Direct-sequence spread-spectrum transmissions multiply the symbol sequence being transmitted with a spreading sequence that has a higher rate than the original message rate. Usually, sequences are chosen such that the resulting spectrum is spectrally white. Knowledge of the same sequence is used to reconstruct the original data at the receiving ...
For example, an IBM PC with an Intel 80486 CPU running at 50 MHz will be about twice as fast (internally only) as one with the same CPU and memory running at 25 MHz, while the same will not be true for MIPS R4000 running at the same clock rate as the two are different processors that implement different architectures and microarchitectures ...