enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oil burner - Wikipedia

   en.wikipedia.org/wiki/Oil_burner

   An oil burner is a part attached to an oil furnace, water heater, or boiler. [1] It provides the ignition of heating oil/biodiesel fuel used to heat either air or water via a heat exchanger . The fuel is atomized into a fine spray usually by forcing it under pressure through a nozzle which gives the resulting flame a specific flow rate, angle ...

3. Firebox (steam engine) - Wikipedia

   en.wikipedia.org/wiki/Firebox_(steam_engine)

   The oil burner nozzle is usually mounted in the front of the firebox, protected by a hood of firebrick, and aimed at the firebrick wall below the firebox door. Dampers control air flow to the oil fire. Schematic of a later steam locomotive firebox boiler, with firebox to the left and indicatively showing two superheater elements to the right.

4. Industrial furnace - Wikipedia

   en.wikipedia.org/wiki/Industrial_furnace

   Furnace burner. The burner in the vertical, cylindrical furnace as above, is located in the floor and fires upward. Some furnaces have side fired burners, such as in train locomotives. The burner tile is made of high temperature refractory and is where the flame is contained. Air registers located below the burner and at the outlet of the air ...

5. Bunsen burner - Wikipedia

   en.wikipedia.org/wiki/Bunsen_burner

   The Teclu burner provides better mixing of air and fuel and can achieve higher flame temperatures than the Bunsen burner. [9] [10] Meker burner – The lower part of its tube has more openings with larger total cross-section, admitting more air and facilitating better mixing of air and gas. The tube is wider and its top is covered with a wire grid.

6. Oil-filter wrench - Wikipedia

   en.wikipedia.org/wiki/Oil-filter_wrench

   Strap-type oil-filter wrench. A ratchet is used to turn it. Strap-type oil-filter wrench. This one has a handle built in. Socket-type oil-filter wrench. It fits over the end of the filter and is turned with a ratchet. It is made of stamped steel. An oil-filter wrench is a tool for removing spin-on type oil filters.

7. Argand lamp - Wikipedia

   en.wikipedia.org/wiki/Argand_lamp

   An Argand lamp used whale oil, seal oil, colza, olive oil [2] or other vegetable oil as fuel which was supplied by a gravity feed from a reservoir mounted above the burner. A disadvantage of the original Argand arrangement was that the oil reservoir needed to be above the level of the burner because the heavy, sticky vegetable oil would not ...