Search results
Results from the WOW.Com Content Network
The digital capacitive technology is based on a non-contacting ceramic sensor mounted inside the load cell body. As the load cell contains no moving parts and the ceramic sensor is not in contact with the load cell body, the load cell tolerates very high overloads (up to 1000%), sideloads, torsion, and stray welding voltages. [3]
Figure 2. Schematic symbol and circuit incorporating the mechanical–electrical analogy for a piezoelectric sensor. Figure 2's detailed model includes the effects of the sensor's mechanical construction and other non-idealities. [12] The inductance L m is due to the seismic mass and inertia of the sensor itself.
Nonintrusive load monitoring was invented by George W. Hart, Ed Kern and Fred Schweppe of MIT in the early 1980s with funding from the Electric Power Research Institute. [3] [4] Figure 1 from US patent 4858141 showing basic process for NILM. The basic process is described in U.S. patent 4,858,141. As shown in figure 1 from the patent, a digital ...
Weigh-in-motion or weighing-in-motion (WIM) devices are designed to capture and record the axle weights and gross vehicle weights as vehicles drive over a measurement site. . Unlike static scales, WIM systems are capable of measuring vehicles traveling at a reduced or normal traffic speed and do not require the vehicle to come to a st
Eddy current sensors are displacement sensors that use the principle of eddy current formation to sense displacement. These sensors measure shaft displacement in rotating machinery and have been around for many years as they offer manufacturers high-linearity, high-speed measurements, and high resolution. [ 1 ]
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
There are several tolerance methods: . The traditional "minimum weight" system where weights below a specified weight are rejected. Normally the minimum weight is the weight that is printed on the pack or a weight level that exceeds that to allow for weight losses after production such as evaporation of commodities that have a moisture content.
Adjustment: Some isolation systems require manual adjustment to compensate for changes in weight load, weight distribution, temperature, and air pressure, whereas other systems are designed to automatically compensate for some or all of these factors. Maintenance: Some isolation systems are quite durable and require little or no maintenance.