Search results
Results from the WOW.Com Content Network
Centrifugal pumps with an internal suction stage such as water-jet pumps or side-channel pumps are also classified as self-priming pumps. [10] Self-Priming centrifugal pumps were invented in 1935. One of the first companies to market a self-priming centrifugal pump was American Marsh in 1938. [citation needed]
The Required NPSH (NPSH R): the head value at the suction side (e.g. the inlet of a pump) required to keep the fluid away from cavitating (provided by the manufacturer). NPSH is particularly relevant inside centrifugal pumps and turbines , which are parts of a hydraulic system that are most vulnerable to cavitation.
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
To reduce drafting friction and obtain a larger flow or higher lift, a larger cross-section of suction hose is employed. For example, using a five-inch (127 mm) hose, a pump that could lift 500 US gallons per minute (30 L/s) up 23 feet (7.0 m) would only be able to lift the same amount of water 12.5 feet (3.8 m) through a 3.5-inch (89 mm) hose.
While centrifugal pumps impart momentum to the fluid by motion of blades, positive displacement pumps transfer fluid by variation in the size of the pump’s chamber. Centrifugal pumps can be of rotor or propeller types, whereas positive displacement pumps may be gear-based, piston-based, diaphragm-based, etc. As a general rule, centrifugal ...
Large industrial condensate pumps may also serve as the feedwater pump. In either case, to force the water into the boiler, the pump must generate sufficient pressure to overcome the steam pressure developed by the boiler. This is usually accomplished through the use of a centrifugal pump.
A self-priming slurry pump is operated from land, and a hose is connected to the pump's intake valve. The self-priming pump draws the slurry to the pump then discharges the material from there. Flooded Suction The flooded suction slurry pump is connected to a tank or hopper and uses gravity to move slurry and liquid from the enclosure.
An axial-flow pump for industrial use. An axial-flow pump, or AFP, is a common type of pump that essentially consists of a propeller (an axial impeller) in a pipe.The propeller can be driven directly by a sealed motor in the pipe or by electric motor or petrol/diesel engines mounted to the pipe from the outside or by a right-angle drive shaft that pierces the pipe.