Search results
Results from the WOW.Com Content Network
But in long-range Wi-Fi, special technologies are used to get the most out of a Wi-Fi connection. The 802.11-2007 standard adds 10 MHz and 5 MHz OFDM modes to the 802.11a standard, and extend the time of cyclic prefix protection from 0.8 μs to 3.2 μs, quadrupling the multipath distortion protection. Some commonly available 802.11a/g chipsets ...
An 802.11n-only network may be impractical for many users because they need to support legacy equipment that still is 802.11b/g only. In a mixed-mode system, an optimal solution would be to use a dual-radio access point and place the 802.11b/g traffic on the 2.4 GHz radio and the 802.11n traffic on the 5 GHz radio. [20]
Wireless LAN (WLAN) channels are frequently accessed using IEEE 802.11 protocols. The 802.11 standard provides several radio frequency bands for use in Wi-Fi communications, each divided into a multitude of channels numbered at 5 MHz spacing (except in the 45/60 GHz band, where they are 0.54/1.08/2.16 GHz apart) between the centre frequency of the channel.
Nodes typically connect in a star or mesh topology. While most individual nodes in a WSAN are expected to have limited range ( Bluetooth , Zigbee, 6LoWPAN , etc.), particular nodes may be capable of more expansive communications ( Wi-Fi , Cellular networks , etc.) and any individual WSAN can span a wide geographical range.
There are wireless range extending devices that conform to all 802.11 protocols. Most 802.11 compliant devices are backward compatible. However, 802.11ac runs at 5 GHz and requires an access point capable of 5 GHz operation. 802.11ac equipment is backward compatible with 802.11n, 802.11g, or 802.11b equipment.
The main difference is the draft 802.11n wireless interface, ... 2.4 GHz, 5 GHz CVQ0 1× USB 2.0 FCC ID: Q87-E3000. Supported by DD-WRT starting at build 14567.
Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.
Better or worse performance with higher or lower frequencies (channels) may be realized, depending on the environment. 802.11n and 802.11ax can use either the 2.4 GHz or 5 GHz band; 802.11ac uses only the 5 GHz band. The segment of the radio frequency spectrum used by 802.11 varies between countries. In the US, 802.11a and 802.11g devices may ...