Search results
Results from the WOW.Com Content Network
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.
The shaded-pole motor is the original type of AC single-phase electric motor, dating back to at least as early as 1890. [1] A shaded-pole motor is a motor, in which the auxiliary winding is composed of a copper ring or bar surrounding a portion of each pole to produce a weakly rotating magnetic field . [ 2 ]
Perhaps the most common use of centrifugal switches is within single-phase, split-phase induction motors. Here, the switch is used to disconnect the starting winding of the motor once the motor approaches its normal operating speed. In this case, the centrifugal switch consists of weights mounted to the shaft of the motor and held near the ...
A DC armature of a miniature motor (or generator) An example of a triple-T armature A partially-constructed DC armature, showing the (incomplete) windings In electrical engineering, the armature is the winding (or set of windings) of an electric machine which carries alternating current. [1]
The windings (coils of wire) on the armature are connected to the commutator segments. Commutators are used in direct current (DC) machines: dynamos (DC generators) and many DC motors as well as universal motors. In a motor the commutator applies electric current to the windings.
parking light 58 58R parking light 58 Window wiper/washer; 53 wiper motor + in 1, 3, 54d, S 53a limit stop + 54, +2 53b limit stop field 3, 54e 53c washer pump 53e stop field 1, 2 53i wiper motor with permanent magnet, third brush for high speed Acoustic warning 71 beeper in H 71a beeper out, low 71b beeper out, high 72 hazard lights switch 85c
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
A transformer supplying a three-wire distribution system has a single-phase input (primary) winding. The output (secondary) winding has a center tap connected to a grounded neutral. As shown in Fig. 1, either end to center has half the voltage of end-to-end. Fig. 2 illustrates the phasor diagram