Search results
Results from the WOW.Com Content Network
Dosage typically includes information on the number of doses, intervals between administrations, and the overall treatment period. [3] For example, a dosage might be described as "200 mg twice daily for two weeks," where 200 mg represents the individual dose, twice daily indicates the frequency, and two weeks specifies the duration of treatment.
Drug titration is the process of adjusting the dose of a medication for the maximum benefit without adverse effects. [ 1 ] When a drug has a narrow therapeutic index , titration is especially important, because the range between the dose at which a drug is effective and the dose at which side effects occur is small. [ 2 ]
In practice, the drug concentration is measured at certain discrete points in time and the trapezoidal rule is used to estimate AUC. In pharmacology, the area under the plot of plasma concentration of a drug versus time after dosage (called “area under the curve” or AUC) gives insight into the extent of exposure to a drug and its clearance ...
In pharmacokinetics, a loading dose is an initial higher dose of a drug that may be given at the beginning of a course of treatment before dropping down to a lower maintenance dose. [ 1 ] A loading dose is most useful for drugs that are eliminated from the body relatively slowly, i.e. have a long systemic half-life .
In clinical pharmacology, dose refers to the amount of drug administered to a person, and dosage is a fuller description that includes not only the dose (e.g., "500 mg") but also the frequency and duration of the treatment (e.g., "twice a day for one week").
The ED50 is commonly used as a measure of the reasonable expectancy of a drug effect, but does not necessarily represent the dose that a clinician might use. This depends on the need for the effect, and also the toxicity. The toxicity and even the lethality of a drug can be quantified by the TD 50 and LD 50 respectively. Ideally, the effective ...
In pharmacology, the volume of distribution (V D, also known as apparent volume of distribution, literally, volume of dilution [1]) is the theoretical volume that would be necessary to contain the total amount of an administered drug at the same concentration that it is observed in the blood plasma. [2]
A low drug load may cause homogeneity problems. A high drug load may pose flow problems or require large capsules if the compound has a low bulk density. By the time phase III clinical trials are reached, the formulation of the drug should have been developed to be close to the preparation that will ultimately be used in the market. A knowledge ...