Search results
Results from the WOW.Com Content Network
In geotechnical engineering, a tieback is a structural element installed in soil or rock to transfer applied tensile load into the ground. Typically in the form of a horizontal wire or rod, or a helical anchor, a tieback is commonly used along with other retaining systems (e.g. soldier piles , sheet piles, secant and tangent walls) to provide ...
Additional vertical and horizontal rebar is then secured to the new elements, a form is erected, and an additional layer of concrete is poured. This modification may be combined with additional footings in excavated trenches and additional support ledgers and tie-backs to retain the span on the bounding walls.
Soil nails were used to stabilize an 18 metres (59 ft) high slope consisting of sandy soil. This method proved to be more cost-effective, while at the same time cut down the construction time when compared to other conventional support methods. [4]: 23 Germany was the next country to investigate soil nailing.
Tieback may refer to: Tieback (geotechnical) , a method of supporting retaining walls Tieback (subsea) , a connection between a new oil and gas discovery and an existing production facility, such as the Brae oilfield
The reinforcing steel in the bottom part of the beam, which will be subjected to tensile forces when in service, is placed in tension before the concrete is poured around it. Once the concrete has hardened, the tension on the reinforcing steel is released, placing a built-in compressive force on the concrete.
Rebar (short for reinforcement bar or reinforcing bar), known when massed as reinforcing steel or steel reinforcement, [1] is a tension device added to concrete to form reinforced concrete and reinforced masonry structures to strengthen and aid the concrete under tension.
The average pay for a reinforcing bar ironworker in residential construction was an hourly wage of $23.59 in early 2009, and rebar ironworkers in commercial and industrial construction earned an hourly wage of $39.11. [12] The typical tools of a reinforcing bar ironworker are pliers, tie wire reels, rodbuster bags, and rebar hooks.
Hurricane ties are in place at the top of the wall as the roof trusses are being placed. A hurricane tie (also known as hurricane clip or strip) is used to help make a structure (specifically wooden structures) more resistant to high winds (such as in hurricanes), resisting uplift, racking, overturning, and sliding. [3]